5B
Manual Transmission Unit Dismounting and Remounting
Dismounting
1) Disconnect negative cable at battery.
2) Remove shift control lever referring to Gear Shift Control Lever Assembly Removal and Installation:M13A Model .
3) Remove propeller shaft No.1 and No.2 referring to Propeller Shaft Removal and Installation .
4) Remove exhaust pipe referring to Exhaust Pipe Removal and Installation:M13A .
5) Remove starting motor from transmission case referring to Starting Motor Removal and Installation .
6) Disconnect clutch cable from clutch release fork referring to Clutch Cable Removal and Installation:M13A Model .
7) Remove cable bracket and clutch housing lower plate from transmission case.
8) Disconnect back up lamp switch coupler (1).
9) Undo wiring harness clamp.
10) Support transmission with transmission jack (3).
11) Remove rear mounting bracket (1).
12) Remove gear shift control arm (2).
13) Remove transmission to engine bolts and nut.
14) Pull transmission out so as to disconnect input shaft from clutch disc, and then lower it.
Remounting
Reverse dismounting procedure for remounting noting the following.
Connect and adjust clutch cable to clutch release fork referring to Clutch Cable Removal and Installation:M13A Model .
Tightening bolts and nuts to specified torque referring to Manual Transmission Unit Components:M13A Model .
Set wiring harness clamps securely.
Fill transmission with specified oil referring to Manual Transmission Oil Change:M13A Model .
Connect battery and check function of engine, clutch and transmission.