9F
Keyless Entry System Circuit Inspection
NOTE:
For M13 engine model, if keyless entry system is in interior light signal mode, change to hazard warning light signal mode referring to “Change of Signal Mode:” under Keyless Entry System (If Equipped) Description (For M13 Engine Model) .
Check that the voltage and continuity between the following terminals and body ground are specifications under each conditions.
If check result is not as specified, check applicable circuit.
If circuit is normal, recheck keyless entry system circuit as follows.
1) Substitute a known-good door lock controller.
2) Register key code referring to Transmitter Code Registration Procedure .
[A]: M13 engine model
[B]: K9K engine model
1. Door lock controller
Keyless Entry System Circuit Check
M13 engine model
Terminal Circuit Specification Condition
2 Key remainder circuit 10 – 14 V Ignition key is in ignition switch.
0 – 1 V Ignition key is not in ignition switch.
4 Door switch & interior light circuit 0 – 1 V Driver side, passenger side or rearend door is open.
10 – 14 V All doors are close.
Figure “A” Fulfill the following conditions.
• All door is close.
• Interior light switch is middle position.
• 15 seconds after pushing “UNLOCK” button on transmitter.
5 Hazard warning signal circuit Figure “B” Push “LOCK” button on transmitter.
Figure “C” Push “UNLOCK” button on transmitter.
[A]: Figure “A” [C]: Figure “C”
[B]: Figure “B”      
K9K engine model
Terminal Circuit Specification Condition
7 Hazard warning signal circuit (right side) Figure “A” Push “LOCK” button on transmitter once.
Figure “B” Push “UNLOCK” button on transmitter once.
8 Hazard warning signal circuit (left side) Figure “A” Push “LOCK” button on transmitter once.
Figure “B” Push “UNLOCK” button on transmitter once.
15 Door switch & interior light circuit 0 – 1 V Driver side, passenger side or rearend door is open.
10 – 14 V All doors are close.
Figure “C” Fulfill the following conditions.
• All door is close.
• Interior light switch is middle position.
• 20 seconds after pushing “UNLOCK” button on transmitter once.
[A]: Figure “A” [C]: Figure “C”
[B]: Figure “B”