9F
Transmitter Code Registration Procedure
If transmitter or door lock controller is replaced with new one or additional transmitter(s) is necessary, register key code(s) as follows.
M13 Engine Model
1) Confirm that the vehicle is the following conditions.
• All doors are closed.
• Ignition key is out of ignition switch.
• Driver side door is unlocked and its window is opened.
2) Disconnect negative (–) cable from battery.
3) After 30 seconds, perform the following procedure within 60 seconds.
a) Connect negative (–) cable to battery.
b) Operate driver side door knob switch from lock to unlock twice.
c) Push “LOCK” button on transmitter and confirm that all doors are operated from lock to unlock.
d) Push driver side door knob switch to lock position.
e) Push “LOCK” button on transmitter twice and confirm that all doors are operated from unlock to lock. With this, code registration is completed.
NOTE:
• Two transmitter codes can be registered.
• When a new transmitter code is registered, the oldest one will be cleared.
K9K Engine Model
1) Make sure that all doors are closed and ignition key is out of ignition key cylinder.
2) Open driver side door.
3) Turn ignition switch to ON position, and then remove ignition key from ignition key cylinder within 10 seconds after that.
4) Push and release driver side door switch (1) at 3 times by hand with 20 seconds after removing ignition key from ignition key cylinder.
5) Turn ignition switch to ON position, and then remove ignition key from ignition key cylinder within 10 seconds after that.
6) Push “UNLOCK” button (2) on transmitter (3) and confirm that all doors are operated from lock to unlock.
with this, code registration is completed.
NOTE:
• Three transmitter codes can be registered.
• When a new transmitter code is registered, the oldest one will be cleared.