10C
Procedure after ECM Replacement
When ECM was replaced, including when replaced because rechecking by using a known-good ECM was necessary during trouble diagnosis, register ECM/Immobilizer Control Module code in ECM by performing following procedure.
1) Perform Steps 1) and 2) described in How to Register Ignition Key:M13A Model . And then turn ignition switch ON.
2) Using SUZUKI scan tool, register ECM/Immobilizer Control Module code in ECM by executing “RECORD ECU (RECORD ECM / lCM)” command in SELECT MODE menu.
NOTE:
For operation procedure of SUZUKI scan tool, refer to SUZUKI scan tool operator’s manual.
3) Make sure that following indicator lamp lights when ignition switch is turned OFF once and then turned ON.
• Vehicle not equipped with immobilizer indicator lamp: malfunction indicator lamp (MIL).
• Vehicle equipped with immobilizer indicator lamp: immobilizer indicator lamp.