10C
How to Register Ignition Key
Register the ignition key with a built-in transponder in Immobilizer Control Module by using the following procedure.
CAUTION:
When registering the ignition key including a transponder into the immobilizer control module by using SUZUKI scan tool, confirm that the knob color of the ignition key to be registered for the vehicle with / without air bag system is as shown below. The ignition key with wrong knob color cannot be registered.
• Knob color of ignition key for vehicle with air bag system: Dark gray
• Knob color of ignition key for vehicle without air bag system: Black
1) Prepare SUZUKI scan tool and cartridge for immobilizer control system.
2) With ignition switch OFF, connect SUZUKI scan tool to data link connector (DLC) (1) located on underside of instrument panel at driver’s seat side.
Special Tool
(A) : SUZUKI scan tool
NOTE:
For operation procedure of SUZUKI scan tool, refer to SUZUKI scan tool operator’s manual.
3) Prepare ignition key with a built-in transponder (1). And then turn ignition switch ON by using it.
2. Key knob
4) Number of Transponder codes for ignition key with a built-in transponder that can be registered in Immobilizer Control Module is limited to 4. If needed, clear all Transponder codes for ignition key with a built-in transponder that have been registered in Immobilizer Control Module by executing the “CLR. TRANS COD (CLEAR TP CODE)” command in the SELECT MODE menu by using SUZUKI scan tool.
NOTE:
When “CLR. TRANS COD (CLEAR TP CODE)” command is executed with the malfunction indicator lamp (if not equipped with immobilizer indicator lamp) ON or the immobilizer indicator lamp ON, it remains ON even after execution of that command is over. It will start flashing when the ignition switch is turned OFF once and then turned ON after some seconds.
5) Using SUZUKI scan tool, register Transponder code in Immobilizer Control Module by executing “ENT. TRANS COD (ENT. TP CODE)” command in SELECT MODE menu.
6) Make sure that following indicator lamp lights when ignition switch is turned OFF once and then turned ON.
• Vehicle not equipped with immobilizer indicator lamp: malfunction indicator lamp (MIL).
• Vehicle equipped with immobilizer indicator lamp: immobilizer indicator lamp.
7) If any other Transponder code for ignition key with a built-in transponder needs to be registered, repeat above Steps 3), 5) and 6).
NOTE:
• Up to 4 Transponder codes for ignition key with a built-in transponder can be registered.
• It is not possible to register the same Transponder code for ignition key with a built-in transponder as the one already registered in Immobilizer Control Module.