10C
Procedure after Immobilizer Control Module Replacement
When Immobilizer Control Module was replaced, including when replaced because rechecking by using a known-good Immobilizer Control Module was necessary during trouble diagnosis, register Transponder code and ECM/Immobilizer Control Module code in Immobilizer Control Module and ECM/Immobilizer Control Module code in ECM by performing following procedure.
CAUTION:
When registering the ignition key including a transponder into the immobilizer control module by using SUZUKI scan tool, confirm that the knob color of the ignition key to be registered for the vehicle with / without air bag system is as shown below. The ignition key with wrong knob color cannot be registered.
• Knob color of ignition key for vehicle with air bag system: Dark gray
• Knob color of ignition key for vehicle without air bag system: Black
1) Perform Steps 1) and 2) described in How to Register Ignition Key:M13A Model .
2) Prepare ignition key with a built-in transponder. And then turn ignition switch ON by using it.
3) Using SUZUKI scan tool, clear all transponder codes registered in Immobilizer Control Module by executing “CLR. TRANS COD (CLEAR TP CODE)” command in SELECT MODE menu.
NOTE:
When “CLR. TRANS COD (CLEAR TP CODE)” command is executed with the malfunction indicator lamp (if not equipped with immobilizer indicator lamp) ON or the immobilizer indicator lamp ON, it remains ON even after execution of that command is over. It will start flashing when the ignition switch is turned OFF once and then turned ON after some seconds.
4) Using SUZUKI scan tool, register Transponder code in Immobilizer Control Module by executing “ENT. TRANS COD (ENT. TP CODE)” command in SELECT MODE menu.
5) Using SUZUKI scan tool, register ECM/Immobilizer Control Module code in both Immobilizer Control Module and ECM by executing “RECORD ECU (RECORD ECM/PCM/ICM)” command in SELECT MODE menu.
6) Make sure that following indicator lamp lights when ignition switch is turned OFF once and then turned ON.
• Vehicle not equipped with immobilizer indicator lamp: malfunction indicator lamp (MIL).
• Vehicle equipped with immobilizer indicator lamp: immobilizer indicator lamp.
7) If any other Transponder code for ignition key with a built-in transponder needs to be registered, repeat above Steps 2), 4) and 6).
NOTE:
• Up to 4 Transponder codes for ignition key with a built-in transponder can be registered.
• It is not possible to register the same Transponder code for ignition key with a built-in transponder as the one already registered in Immobilizer Control Module.