7B
Lip Seal Removal and Installation (M13A Model)
Reference: Compressor Assembly Components
Removal
1) Remove magnet clutch referring to Magnet Clutch Removal and Installation (M13A Model) .
2) Remove front head mounting bolts (10 pcs).
1. Front head
3) Remove front head (1) by pushing compressor shaft (2).
NOTE:
Be careful not to remove cylinder (3) from compressor body assembly (4).
4) Remove O-ring (5).
5) Remove lip seal from front head (1) using bearing remover (2).
Installation
1) Press-fit lip seal (1) into front head (2) using special tool.
Special Tool
(A) : 09991–06050
CAUTION:
Do not reuse lip seal (1) once removed from compressor.
2) Coat special tool surface with compressor oil and place it on compressor shaft (1).
Special Tool
(A) : 09991–06040
3) Install O-ring (1) to compressor body assembly (2).
4) Apply compressor oil to lip seal and O-ring (1).
5) Install front head (3) to compressor body assembly (2).
Special Tool
(A) : 09991–06040
6) Tighten new front head bolts to specified torque.
Tightening torque
Front head bolts ( a ): 14 N·m ( 1.4 kg-m, 10.5 lb-ft)
Front head bolts ( b ): 23 N·m ( 2.3 kg-m, 17 lb-ft)
NOTE:
Tighten bolt (a) first, and next (b).