Scan Tool Data - Suzuki Jimny Workshop Manual
10C
Scan Tool Data
ICM
As the data value given below are standard values estimated on the basis of values obtained from the normally operating vehicles by using SUZUKI scan tool, use them as reference values. Even when the vehicle is in good condition, there may be cases where the checked value does not fall within normal conditions and reference values. Therefore, judgement as abnormal should not be made by checking with there data alone. Also, conditions in the table below that can be checked by SUZUKI scan tool are those detected by Immobilizer Control Module and output from Immobilizer Control Module as commands.
| Scan Tool Data | Vehicle Condition | Normal Condition/Reference Values |
|---|---|---|
 IGNITION SWITCH |
Ignition switch at ON position | ON |
|
TRANSPONDER |
Ignition switch at ON position | DETECTED |
|
TRANS CODE |
Ignition switch at ON position | MATCHED |
|
SYSTEM |
Ignition switch at ON position | UNPROTECTED |
|
LEARNING MODE |
Ignition switch at ON position | LOCKED |
|
TRANS CODE REG |
Ignition switch at ON position | RGSTD |
Scan Tool Data Definitions
IGNITION SWITCH
ON: Ignition switch at ON position
OFF: Ignition switch at OFF position
TRANSPONDER
DETECTED: Transponder code in ignition key is detected by Immobilizer Control Module.
NOT DETECTED: Transponder code in ignition key is not detected by Immobilizer Control Module.
TRANS CODE
MATCHED: Transponder code in ignition key matches with the one registered with Immobilizer Control Module.
NOT MATCHED: Transponder code in ignition key does not match with the one registered with Immobilizer Control Module.
SYSTEM
PROTECTED: The immobilizer control system is protecting the engine not to be started up. Therefore, the engine can not be started up.
UNPROTECTED: The immobilizer control system is allowing the engine to be started up. Therefore, the engine can be started up.
LEARNING MODE
LOCKED: Registration of ignition key with Immobilizer Control Module is not allowed.
UNLOCKED: Registration of ignition key with Immobilizer Control Module is allowed.
TRANS CODE REG
NOT RGSTD: The transponder code is not registered with Immobilizer Control Module.
RGSTD: The transponder code is registered with Immobilizer Control Module.