10C
Immobilizer Control Module Removal and Installation
Removal
1) Disconnect negative (–) cable at battery.
2) Remove steering column hole cover.
3) [Vehicle equipped with air bag system]
Remove steering column mounting bolts, then remove steering column upper and lower cover.
4) Disconnect coupler at Immobilizer Control Module.
5) Remove Immobilizer Control Module (1).
2. Steering support member
3. Steering shaft
[A]: For vehicle not equipped with air bag system
[B]: For vehicle equipped with air bag system
Installation
Reverse removal procedure for installation.
NOTE:
After replacing Immobilizer Control Module, be sure to register Transponder code and ECM/Immobilizer Control Module code in Immobilizer Control Module and ECM/Immobilizer Control Module code in ECM by performing procedure described in Procedure after Immobilizer Control Module Replacement:M13A Model .