9I
Crank Drive Removal and Installation
Removal
1) Close sliding roof glass.
2) Remove sliding roof handle (1) and remove sliding roof handle garnish (2).
3) Loosen crank drive screws (1) and then remove crank drive (2).
Installation
1) Adjust sliding roof assembly and crank drive for assembling position. Refer to Sliding Roof Assembly Disassembly and Reassembly .
2) Reverse removal procedure for installation.
Install crank drive (1) with turned it lock pin (2) to forward direction as shown in the figure.
Tighten crank drive handle screw (1) to specified torque.
Tightening torque
Crank drive handle screw ( a ): 2 N·m ( 0.2 kg-m, 1.4 lb-ft)