9H
Head Lining Removal and Installation
Removal
1) Remove interior light (1).
2) Remove head lining clip (2).
3) Remove sun visor (3).
4) Mark mating marks (1) on roof handle (2) and roof garnish (3), if equipped sliding roof.
5) Remove roof handle (2) and roof garnish (3), if equipped sliding roof.
6) Remove roof trim (1), if equipped sliding roof.
7) Remove assistant grip (2).
8) Remove door opening trim (3) and remove inner trims covering head lining (4).
9) Remove rear speaker cover (5).
10) Remove head lining clips (6) (5 place) and remove head lining.
NOTE:
Adhesive is used to attach head lining for vehicle without sliding roof.
Clear adhesive from headlining and roof after removing head lining if applied.
Installation
Reverse removal procedure to install head lining noting the following instructions.
• Attach adhesive tape (1) to head lining (2) as shown figure.
• Install interior trim in order of (a), (b), (c).
• When install roof handle (1), match marks (2) on roof handle (1) and roof garnish.
• Tighten roof handle screw (4) to specified torque.
Tightening torque
Roof handle screw ( a ): 2 N·m ( 0.2 kg-m, 1.4 lb-ft)
• Tighten sun visor screw to specified torque.
Tightening torque
Sun visor screw ( a ): 4 N·m ( 0.4 kg-m, 2.8 lb-ft)
• Install sliding roof trim (1) as shown in the figure.