9F
Rearend Door Lock Assembly Removal and Installation
Removal
1) Remove inside lock knob.
2) Remove door trim.
3) Remove door sealing cover (1).
2. Adhesive
4) Remove door lock control rod (2).
5) Disconnect control rod (3).
6) Disconnect door lock motor lead wire.
7) Remove lock assembly.
1. Outside door handle
Installation
Reverse removal procedure to install rearend door lock assembly noting the following points.
• Adjust door latch striker so that its center aligns with the center of groove in door latch base.
To adjust door latch and striker with each other, insert proper number of shims (1) below the bottom of striker, as shown.
• Move rubber cushion (1) installed at the left side of rearend door to align it with its guide.