9B
Rear Fog Light Circuit Inspection (If Equipped)
1)
Check for continuity between terminals at each switch position as shown in the figure.
If check result is not as specified, replace switch.
If check result is specified, go to next step.
2)
Connect battery positive terminal to terminal “IG” and negative terminal to terminal “E2”.
3)
Measure voltage between the following terminals.
[When rear fog light switch is at ON position]
•
Between “L” and battery negative terminal: 10 – 14 V
•
Between “E1” and battery negative terminal: 10 – 14 V
[When rear fog light switch is at OFF position]
•
Between “L” and battery negative terminal: 0 V
•
Between “E1” and battery negative terminal: 0 V
If not, replace switch.