Passenger Air Bag (Inflator) Module Removal and Installation - Suzuki Jimny Workshop Manual
8B
Passenger Air Bag (Inflator) Module Removal and Installation
WARNING:
•
Never attempt to disassemble or repair the passenger air bag (inflator) module. If any abnormality is found, be sure to replace it with new one as an assembly.
• Be sure to read Precautions on Service and Diagnosis of Air Bag System before starting to work and observe every precaution during work. Neglecting them may result in personal injury or undeployment of the air bag when necessary.
• Be sure to read Precautions on Service and Diagnosis of Air Bag System before starting to work and observe every precaution during work. Neglecting them may result in personal injury or undeployment of the air bag when necessary.
Removal
1)
Disconnect negative cable at battery.
2)
Disable air bag system. Refer to
Disabling Air Bag System
.
3)
Remove passenger air bag (inflator) module attaching bolts (2) passenger air bag (inflator) module (1) from vehicle.
Installation
1)
Install passenger air bag (inflator) module (1) to instrument panel.
2)
Tighten passenger air bag (inflator) module attaching bolt (2) to specified torque.
Tightening torque
Passenger air bag (inflator) module mounting bolt
(
a
):
23
N·m (
2.3
kg-m,
16.5
lb-ft)
3)
Connect negative cable to battery.
4)
Enable air bag system. Refer to
Enabling Air Bag System
.