8B
DTC B1044 / B1048: Driver / Passenger Pretensioner Initiator Circuit Short to Power Circuit
DTC Will Set when
The voltage measured at driver or passenger seat belt pretensioner initiator circuit is above a specified value for specified time.
Flow Test Description
Step 1: Check whether malfunction is in seat belt pretensioner.
Step 2: Check seat belt pretensioner initiator circuit in seat belt pretensioner harness.
Step 3: Check seat belt pretensioner initiator circuit in air bag harness.
Troubleshooting
Step Action YES NO
1
1) With ignition switch OFF, remove quarter lower trim of applicable side.
2) Disconnect connector “Q04” or “Q06” connector from seat belt pretensioner.
3) Check proper connection to applicable seat belt pretensioner at terminals in “Q04” or “Q06” connector.
4) If OK, then connect special tools (A), (B) and (C) to “Q04” or “Q06” connector.
Special Tool
(A) : 09932–76010
(B) : 09932–75010
(C) : 09932–78310
With ignition switch ON, does DTC B1044 or B1048 still exist?
Go to Step 2.
Ignition switch OFF.
Replace seat belt pretensioner referring to Front Seat Belt with Pretensioner Removal and Installation .
2
1) With ignition switch OFF, disconnect special tools (A), (B) and (C) from “Q04” or “Q06” connector.
2) Disconnect connector “L31” or “L33” from air bag wire harness in floor harness.
3) Check proper connection to air bag wire harness at terminals in “L31” or “L33” connector.
4) If OK, then connect special tools (B) and (D) to “L31” or “L33” connector.
Special Tool
(A) : 09932–76010
(B) : 09932–75010
(C) : 09932–78310
(D) : 09932–78340
With ignition switch ON, does DTC B1044 or B1048 still exist?
Go to Step 3.
Repair short “YEL” or “YEL/RED” wire circuit to power circuit.
3
1) With ignition switch OFF, disconnect special tools (B) and (D) from seat belt pretensioner wire harness connector “L31” or “L33”.
Special Tool
(B) : 09932–75010
(D) : 09932–78340
2) Disconnect SDM connector “Q60” from SDM.
3) Measure voltage.
a) DTC B1044: between “G102-11” terminal and body ground, and between “G102-12” terminal and body ground.
Special Tool
(A) : 09932–76010
b) DTC B1048: between “G102-5” terminal and body ground, and between “G102-6” terminal and body ground.
Special Tool
(A) : 09932–76010
With ignition switch ON, is voltage 1 V or less?
Substitute a known-good SDM and recheck.
DTC B1044:
Repair short “WHT” or “PNK” wire circuit to power circuit.
DTC B1048:
Repair short from “BRN” or “LT GRN” wire circuit to power circuit.
NOTE:
Upon completion of inspection and repair work, perform the following items.
Reconnect all air bag system components, ensure all components are properly mounted.
Clear DTCs (Refer to DTC Clearance .), if any.
Repeat Air Bag Diagnostic System Check to confirm that the trouble has been corrected.