Step | Action | YES | NO |
---|---|---|---|
1 |
1)
With ignition switch OFF, disconnect passenger air bag (inflator) module connector “G62” behind the glove box.
2)
Check proper connection to passenger air bag (inflator) module at terminals in “G62” connector.
3)
If OK, then connect special tools (B) and (C) to passenger air bag (inflator) module connector “G62”.
With ignition switch ON, does DTC B1019 still exist?
|
Go to Step 2.
|
Ignition switch OFF.
Replace passenger air bag (inflator) module referring to
Passenger Air Bag (Inflator) Module Removal and Installation
.
|
2 |
1)
With ignition switch OFF, disconnect special tools (B) and (C) from “G62” connector and SDM connector “G102” from SDM respectively.
2)
Release shorting bar in SDM connector inserting release tool (1) included in special tool (A).
3)
Measure voltage from “G102-7” terminal to body ground.
With ignition switch ON, is voltage 1 V or less?
|
Go to Step 3.
|
Repair short from “YEL/RED” wire circuit to power circuit.
|
3 |
1)
Measure voltage from “G102-8” terminal to body ground.
With ignition switch ON, is voltage 1 V or less?
|
Substitute a known-good SDM and recheck.
|
Repair short from “YEL” wire circuit to power circuit.
|