8B
Air Bag Diagnostic System Check Flow
Flow Test Description
Step 1: Check that “AIR BAG” warning lamp lights.
Step 2: Check that “AIR BAG” warning lamp lights.
Step 3: Check diagnosis switch circuit.
Step 4: Check that “AIR BAG” warning lamp flashes 6 times after ignition switch is turned ON.
Step 6: Check that history codes are in SDM memory. (Using SUZUKI scan tool)
Step 7: Check that history codes are in SDM memory. (Using monitor coupler)
Step 9: Check that current code is in SDM memory. (Using SUZUKI scan tool)
Step 10: Check that current code is in SDM memory. (Using monitor coupler)
Diagnostic Flow
Step Action YES NO
1
1) Make sure that battery voltage is about 11 V or higher.
2) Note “AIR BAG” warning lamp as ignition switch is tuned ON.
Does “AIR BAG” warning lamp come ON when ignition switch is tuned ON?
Go to Step 2.
2
Does “AIR BAG” warning lamp come ON steady?
Go to Step 3.
3
Does “AIR BAG” warning lamp keep flashing (indicating DTC) when ignition switch is ON?
Go to Step 4.
4
Does “AIR BAG” warning lamp turn OFF, after flashing 6 times?
Go to Step 5.
Go to Step 8.
5
Do you have SUZUKI scan tool?
Go to Step 6.
Go to Step 7.
6
1) Check DTC using SUZUKI scan tool referring to DTC Check .
Is “NO CODES” displayed on SUZUKI scan tool?
Air bag system is in good condition.
An intermittent trouble has occurred at some place.
Check the connector harness, etc. related to the sensed DTC.
Then clear DTC (Refer to DTC Clearance .) and repeat this flow.
7
1) Check DTC not using SUZUKI scan tool, referring to DTC Check .
Is flashing pattern No.12 indicated on “AIR BAG” warning lamp?
Air bag system is in good condition.
An intermittent trouble has occurred at some place.
Check the connector harness, etc. related to the sensed DTC.
Then clear DTC (Refer to DTC Clearance .) and repeat this flow.
8
Do you have SUZUKI scan tool?
Go to Step 9.
Go to Step 10.
9
1) Check DTC using SUZUKI scan tool, referring to DTC Check .
Is “NO CODES” displayed on SUZUKI scan tool?
Substitute a known-good SDM and recheck.
Check and repair according to flow corresponding to that DTC.
10
1) Check DTC not using SUZUKI scan tool, referring to DTC Check .
Is flashing pattern No.12 indicated on “AIR BAG” warning lamp?
Substitute a known-good SDM and recheck.
Check and repair according to flow corresponding to that DTC.