6D
Steering Gear Box Removal and Installation
Removal
1) Remove steering lower shaft joint bolt (2).
2) Remove cotter pin and drag rod end nut from pitman arm (1). icon 
3) Disconnect drag rod end (2) from pitman arm (1), using special tool.
Special Tool
(A) : 09913–65210
4) Remove radiator support member.
5) Remove steering gear box bolts, and remove steering gear box (1).
6) Remove pitman arm mounting nut (4).
7) Make match marks (3) on pitman arm (1) and sector shaft (2), for a guide during reinstallation.
8) Remove pitman arm (1) by using puller.
Installation
Reference: Steering Gear Box Inspection and Adjustment
Reverse removal procedure to install steering gear box.
1) Install pitman arm (1) to sector shaft (2) of steering gear box with match marks (3) aligned as shown in the figure and torque to specification.
Tightening torque
Pitman arm mounting nut ( a ): 135 N·m ( 13.5 kg-m, 98.0 lb-ft)
2) Install sector shaft (2) to steering lower shaft joint (1).
Tighten joint bolt to specified torque.
NOTE:
Align flat part (3) of sector shaft with bolt hole of lower shaft joint as shown. Then insert sector shaft into lower shaft joint.
Tightening torque
Steering lower shaft joint bolt ( a ): 25 N·m ( 2.5 kg-m, 18.0 lb-ft)
3) Install steering gear box (1) mounting bolts (2), (3) with short bolt (3) positioned as shown in the figure.
Tighten nuts and bolt to specified torque.
Tightening torque
Steering gear box mounting bolt and nut ( a ): 80 N·m ( 8.0 kg-m, 58.0 lb-ft)
2. Steering gear box
4) Install radiator support member.
5) Connect drag rod (2) to pitman arm (1).
Tighten drag rod end nut to specified torque.
NOTE:
• After tightening drag rod end nut to specified torque, match nut slot by minimum tightening with hole of drag rod end for insertion of cotter pin (rotation angle 60° max).
Tightening torque
Drag rod end nut ( a ): 35 N·m ( 3.6 kg-m, 26.0 lb-ft)
6) Bend new cotter pin (3).