Clutch Operating Cylinder Disassembly and Assembly
1) Remove boot and then push rod.
2) Remove piston (2) by blowing compressed air into bolt hole (1) where hose was connected, using care to prevent it from jumping out.
Before installation, wash each part in specified brake fluid.
2) Apply brake fluid to piston assembly and inside of cylinder.
3) Install piston assembly (1) into cylinder. When inserting it, be careful not to cause damage to lip of piston cup (2).
4) Apply grease to piston side spheral end of push rod, and then install boot and push rod.
: Grease 99000–25100 ( SUZUKI Silicone Grease )