Clutch Fluid Pipe and Hose Removal and Installation - Suzuki Jimny Workshop Manual
Home
Home
5C
Clutch Fluid Pipe and Hose Removal and Installation
Reference: Clutch Fluid Pipe and Hose Components:K9K Model
Removal
1)
Remove dust and dirt from each joint of hose and pipe to be disconnected and clean around reservoir cap.
2)
Take out fluid with syringe or such from brake master cylinder reservoir.
3)
Disconnect each fluid pipe and hose referring to
Clutch Fluid Pipe and Hose Components:K9K Model
.
NOTE:
To disconnect pipe (1) from hose (2), separate them by using flare nut wrench (4) and spanner (3) so as not to kink them.
Installation
Reference: Clutch Fluid Pipe and Hose Inspection:K9K Model
Reverse removal procedure for installation, noting the following instruction.
CAUTION:
Do not allow pipe and hose to contact hard against vehicle body or other parts.
•
Install each clamp securely.
•
For installation angle of hose, refer to
Clutch Fluid Pipe and Hose Components:K9K Model
.
•
Install E-ring (1) securely as shown.
•
Tighten each bolt and nut to specified torque referring to
Clutch Fluid Pipe and Hose Components:K9K Model
.
NOTE:
To connect pipe to hose, connect them by using flare nut wrench and spanner so as not to kink them.
2.
hose
3.
Pipe
•
After installation, bleed air from system. (Refer to
Air Bleeding of Brake System
.)
•
Check fluid leakage.
•
Add fluid to MAX level of reservoir.
Home