5B
Output Shaft Assembly Disassembly and Reassembly
Disassembly
1) Remove output shaft rear snap ring.
CAUTION:
To avoid gear teeth from being damaged, support gear with flat side of bearing puller when removing gear using bearing puller.
2) Apply bearing puller to output shaft front bearing (1), and drive out output shaft front bearing, output shaft gear (2) and output shaft rear bearing (3) all at once from output shaft using press.
Reassembly
1) Clean all components thoroughly, inspect them for any abnormality and replace with new ones as necessary.
2) Drive in output shaft front bearing (1), output shaft gear (2) and output shaft rear bearing (3) using special tool and press.
Special Tool
(A) : 09941–74910
3) Install output shaft rear snap ring.