5A
Pressure Control Solenoid Valve Removal and Installation
Removal
1) Disconnect negative cable at battery.
2) Remove A/T fluid level gauge.
3) Lift up vehicle.
4) Remove drain plug and drain A/T fluid.
5) Install drain plug.
Tightening torque
A/T fluid drain plug : 17 N·m ( 1.7 kg-m, 12.5 lb-ft)
6) Remove exhaust pipe referring to Exhaust Pipe Removal and Installation:M13A .
7) Remove oil filler tube (1).
8) Remove A/T oil pan (1) and oil pan gasket.
9) Remove oil strainer assembly (1).
10) Remove transmission fluid temperature sensor (1) from sensor clamp.
11) Disconnect solenoid connectors (2).
12) Remove valve body assembly referring to Automatic Transmission Unit Disassembly and Reassembly .
13) Remove pressure control solenoid valve referring to Automatic Transmission Unit Disassembly and Reassembly .
Installation
Reference: Pressure Control Solenoid Valve Inspection
Reverse removal procedure to install pressure control solenoid valve and valve body assembly noting the following points.
• For detail of pressure control solenoid valve installation, refer to Automatic Transmission Unit Disassembly and Reassembly .
• For detail of valve body assembly installation, refer to Automatic Transmission Unit Disassembly and Reassembly .
• For detail of installing wire harness for solenoid valves and sensor, refer to Automatic Transmission Unit Disassembly and Reassembly . Use new O-rings.
• For detail of A/T oil pan and oil strainer assembly installation, refer to Automatic Transmission Unit Disassembly and Reassembly . Use new oil pan gasket.
• Pour A/T fluid and check fluid level according to procedure described in A/T Fluid Change .
• Check for fluid leakage after warning up A/T.