5A
Input Shaft Speed Sensor Removal and Installation
Removal
1) Disconnect negative cable at battery.
2) Disconnect input shaft speed sensor connector.
3) Remove input shaft speed sensor (1) by removing its bolt.
Installation
Reference: Input Shaft Speed Sensor Inspection
1) Apply A/T fluid to input shaft speed sensor O-ring.
2) Install input shaft speed sensor (1) to A/T case and tighten bolt (2) to specified torque.
Tightening torque
Input shaft speed sensor bolt ( a ): 5.5 N·m ( 0.55 kg-m, 4.0 lb-ft)
3) Connect input shaft speed sensor connector to input shaft speed sensor (1).
4) Connect negative cable to battery.