5A
Selector Rod Removal and Installation
Reference: Select Control System Components
Reference: Selector Rod Adjustment
Removal
1) Hoist vehicle.
2) Remove clips on both ends of selector rod.
3) Remove selector rod from transmission and selector lever assembly.
Installation
Install select cable by reversing removal procedure.
The important steps in installation are as follows.
• Apply grease to manual selector lever pin.
: Grease 99000–25010 ( SUZUKI Super Grease A )
• Tighten nuts to specified torque.
Tightening torque
Manual selector rod nut ( a ): 7 N·m ( 0.7 kg-m, 5.0 lb-ft)
• Adjusting procedure is referring to Selector Rod Adjustment .