DTC detecting condition | Trouble area |
---|---|
Voltage of TCC solenoid valve TCM terminal is high although TCM is commanding TCC solenoid to turn OFF. |
•
TCC solenoid valve circuit shorted to ground.
• Malfunction of TCC solenoid valve • TCM |
Step | Action | YES | NO |
---|---|---|---|
1 |
Was
A/T System Check
performed?
|
Go to Step 2.
|
Go to
A/T System Check
.
|
2 |
Check TCC Solenoid Valve Circuit for IG Short
1)
Connect valve body harness connector.
2)
Disconnect TCM connectors.
3)
Check for proper connection to TCM at terminal “E121-5” [A] or “E123-12” [B].
4)
If connection is OK, turn ignition switch ON and measure voltage between terminal “E121-5” [A] or “E123-12” [B] of disconnected harness side TCM connector and ground.
Is it 0 – 2 V?
|
Go to Step 3.
|
“BLK/YEL” circuit shorted to power circuit.
|
3 |
Check TCC Solenoid Valve Resistance
1)
Turn ignition switch OFF.
2)
Disconnect valve body harness connector (1) on automatic transmission (2).
3)
Check for proper connection to solenoid at “BLK/YEL” circuit.
4)
Check resistance of solenoid valve.
Resistance of TCC solenoid valve
Resistance between TCC solenoid valve terminals of transmission side valve body harness connector: 11 – 15 Ω at 20 °C (68 °F)
Resistance between TCC solenoid valve terminals of transmission side valve body harness connector and transmission body: Infinity
Is check results satisfactory?
|
Intermittent trouble or faulty TCM. Check for intermittent referring to
Intermittent and Poor Connection Inspection
. If OK, substitute a known-good TCM and recheck.
|
Replace TCC solenoid valve or lead wire.
|