Rear Brake Hose / Pipe Components - Suzuki Jimny Workshop Manual
4A
Rear Brake Hose / Pipe Components
CAUTION:
•
Position clamps to white marks on two brake pipes.
• Be sure to obtain more than 3 mm (0.118 in.) clearance between axle housing and brake pipe.
• Install clamps properly referring to the figure below and tighten bolts.
• When installing hose, make sure that it has no twist or kink.
• Be sure to obtain more than 3 mm (0.118 in.) clearance between axle housing and brake pipe.
• Install clamps properly referring to the figure below and tighten bolts.
• When installing hose, make sure that it has no twist or kink.
M13 Engine Model
| T: | Top side | 2. | Rear axle housing | 5. | Fuel tank | 8. | Brake pipe (vehicle with LSPV) |
| R: | Right side | 3. | Rear wheel cylinder | 6. | Chassis frame | a-b: | Clamp |
| 1. | Clamp | 4. | LSPV (if equipped) | 7. | Fuel pipe |
:
|
Tightening torque |
K9K Engine Model
| [A]: | For vehicle without ABS | 1. | Clamp | 6. | To master cylinder |
| [B]: | For vehicle with ABS | 2. | Rear axle housing | 7. | To rear brake or LSPV (if equipped) |
| F: | Front side | 3. | Rear wheel cylinder | 8. | Brake pipe (vehicle with LSPV) |
| R: | Right side | 4. | LSPV (if equipped) | a-g: | Clamp |
| T: | Top side | 5. | Fuel tank |
:
|
Tightening torque |