4A
Brake (Stop) Light Switch Inspection
M13 Engine Model
Adjustment should be made as follows when installing switch. Pull up brake pedal toward you and while holding it there, adjust switch position so that clearance between end of thread and brake pedal is specified. Then tighten lock nut to specified torque.
Clearance between brake pedal and brake (stop) light switch
“c”: 1.5 – 2.0 mm (0.06 – 0.08 in.)
Tightening torque
Stop light switch lock nut ( a ): 6.5 N·m ( 0.65 kg-m, 4.7 lb-ft)
K9K Engine Model
Adjustment should be made as follows when installing switch. Pull up brake pedal toward you and while holding it there, adjust switch position so that clearance between end of thread and brake pedal is as specified. Then adjust stop light switch assembly position and lock it by turning clockwise.
Clearance between brake pedal and brake (stop) light switch
“a”: 0.5 – 1.5 mm (0.02 – 0.06 in.)