3C
Output Shaft Snap Ring Adjustment
1) Install removed output shaft snap ring to output shaft.
2) Measure clearance “a” between snap ring (1) and end face of output rear shaft (2).
3) Remove snap ring, and then measure removed snap ring thickness “b”.
4) Obtain adjusting snap ring thickness “c” by the following equation.
“c” = “a” + “b” – 0.05 mm (0.002 in.)
5) Select snap ring with a thickness nearest calculated snap ring thickness “c” by the following.
6) Install selected snap ring to output shaft.
7) Check clearance “a” between snap ring and end face of output rear shaft, again. If it is more than 0.11 mm (0.004 in.), repeat step 2) through 7).
Available snap ring thickness
Identification mark Thickness
0 2.30 mm (0.091 in.)
1 2.36 mm (0.093 in.)
2 2.42 mm (0.095 in.)
3 2.48 mm (0.098 in.)
4 2.54 mm (0.100 in.)
5 2.60 mm (0.102 in.)
6 2.12 mm (0.083 in.)
7 2.18 mm (0.086 in.)
8 2.24 mm (0.088 in.)
3. Front drive clutch hub