Shift Fork Shaft Assembly Inspection - Suzuki Jimny Workshop Manual
3C
Shift Fork Shaft Assembly Inspection
•
Using feeler gauge, check clearance between high & low shift fork (1) and reduction clutch sleeve (2).
If clearance “a” is out of specification, replace reduction clutch sleeve and high & low shift fork.
•
Using feeler gauge, check clearance between front drive gear shift fork (1) and front drive clutch hub sleeve (2).
If clearance “a” is out of specification, replace front drive clutch hub sleeve and front drive gear shift fork.
If clearance “a” is out of specification, replace reduction clutch sleeve and high & low shift fork.
Clearance Between Reduction Clutch Sleeve and High & Low Shift Fork “a”
0.1 – 0.4 mm (0.004 – 0.015 in.)
If clearance “a” is out of specification, replace front drive clutch hub sleeve and front drive gear shift fork.
Clearance Between Front Drive Clutch Hub Sleeve and Front Drive Gear Shift Fork “a”
0.15 – 0.35 mm (0.006 – 0.013 in.)
