DTC Table - Suzuki Jimny Workshop Manual
3C
DTC Table
NOTE:
DTC which had already existed when ignition switch was turned ON may not be stored.
Even in such a case, current malfunction is displayed.
| DTC (Flashing pattern of 4WD indicator) | Detecting item | Detecting condition | Detection logic | Flashing 4WD indicator and 4WD low indicator at the same time |
|---|---|---|---|---|
| 12 | — | Normal (No malfunction DTC is detected) | — | — |
13
|
“2WD” Switch Circuit | Monitor signal of “2WD” switch is ON for specified time. | 1 D/C | 1 D/C |
|
14
|
“4WD” Switch Circuit | Monitor signal of “4WD” switch is ON for specified time. | 1 D/C | 1 D/C |
|
15
|
“4WD-L” Switch Circuit | Monitor signal of “4WD-L” switch is ON for specified time. | 1 D/C | 1 D/C |
|
27
|
4WD Switch and 4WD Low Switch Malfunction | Monitor signal of 4WD low switch is ON even if monitor signal of 4WD switch is OFF. | 1 D/C | 1 D/C |
|
31
|
Transfer Shift Actuator Motor Drive Circuit is Open | Transfer shift actuator limit switch is unchanged even if command signal of transfer shift actuator motor is output. | 1 D/C | 1 D/C |
|
35
|
Transfer Shift Actuator Limit Switch Malfunction | Abnormality of ON/OFF combination in transfer shift actuator limit switch is detected. | 1 D/C | 1 D/C |
|
41
|
Vehicle Speed Malfunction | Vehicle speed signal is not input for specified time at driving. | 3 D/C | 3 D/C |
|
42
|
Engine Speed Malfunction | Engine revolution signal is not input for specified time at driving. | 3 D/C | 3 D/C |
|
43
|
Battery Voltage Malfunction | Voltage of terminal E74-3 is lower than 2 V or higher than 18 V. | 1 D/C | 1 D/C |
|
46
|
Clutch Pedal Switch Circuit Short | Monitor signal of clutch pedal switch is ON for specified time at driving. | 3 D/C | 3 D/C |
|
48
|
A/T shift switch (“N” range) Circuit | Monitor signal of A/T shift switch (“N” range) is ON for specified time at driving. | 3 D/C | 3 D/C |
|
65
|
Vacuum Switch Circuit | Monitor signal of vacuum switch is ON for specified time even if monitor signal of VSV2 is OFF. | 1 D/C | 1 D/C |
|
67
|
VSV1 Malfunction | Monitor signal of VSV1 is ON even if command signal of VSV1 is OFF. | 1 D/C | 1 D/C |
|
68
|
VSV2 Malfunction | Monitor signal of VSV2 is ON even if command signal of VSV2 is OFF. | 1 D/C | 1 D/C |