1. | Companion flange | 15. | Thrust washer |
2. | Drive bevel / Hypoid gear set | 16. | Differential side bearing |
3. | Drive bevel pinion spacer | 17. | Differential side bearing adjuster |
4. | Shim | 18. | Lock plate |
5. | Drive bevel pinion rear bearing | 19. | Pinion shaft No.2 |
6. | Drive bevel pinion front bearing | 20. | Pinion joint |
![]() |
Oil seal
: Apply grease 99500-25010 to oil seal lip. |
21. | Pinion washer |
![]() |
Flange nut
: After tightening nut so as rotational torque of drive bevel pinion to be in specified torque, caulk nut securely. |
![]() |
Bevel gear bolt
: Apply thread lock cement 99000-32110 to thread. |
![]() |
Differential carrier assembly
: Apply sealant 99000-31110 to mating face with axle housing. |
![]() |
Differential case bolt
: Apply thread lock cement 99000-32110 to thread. |
10. | Differential pinion |
![]() |
Differential carrier bolt
(Bolt length: 30.5 mm (1.201 in.)) : Apply sealant 99000-31110 to thread. |
11. | Differential gear |
![]() |
Differential carrier bolt
(Bolt length: 37.5 mm (1.476 in.)) : Apply sealant 99000-31110 to thread. |
12. | Pinion shaft No.1 |
![]() |
Tightening torque |
13. | Differential left case |
![]() |
Do not reuse. |
14. | Differential right case |
![]() |
Apply differential oil. |