1D
Main Bearings, Crankshaft and Cylinder Block Components
icon : Tightening torque 8. Crankshaft
icon : Do not reuse. 9. Thrust bearing
icon : Apply engine oil to inside/sliding surface.
 		 icon 10. Rear oil seal housing
: Apply specified amount [A] of sealant 99000-31250 to mating surface.
“a”: 3 mm (0.12 in.) 11. Rear oil seal
“b”: 2 mm (0.08 in.) 12. Input shaft bearing
1. CKP sensor (if equipped) 13. Flywheel
2. Knock sensor 14. Main bearing cap
3. Cylinder block icon 15. Flywheel mounting bolt
: Apply sealant 99000-31110 to thread part.
4. Venturi plug 16. Rear oil seal housing mounting bolt
5. Main bearing 17. Main bearing cap No.2 bolt
6. Sensor plate icon 18. Main bearing cap No.1 bolt
1) Tighten all bolts to 50 N·m (5.0 kg-m)
2) Then, turn all bolts to 60°
7. Crankshaft timing sprocket key