Pistons, Piston Rings, Connecting Rods and Cylinders Components
1. Top ring 8. Piston pin
2. 2nd ring 9. Piston pin circlip
3. Oil ring 10. Bearing cap nut
1) Tighten all nuts to 15 N·m (1.5 kgf-m).
2) Turn all nuts to 45°.
3) Then, turn all nuts to 45° once again.
4. Piston icon : Tightening torque
icon 5. Connecting rod
: Apply engine oil to sliding surface except inner surface of big end, and rod bolts. Make sure rod bolt diameter when reuse it due to plastic deformation tightening. Refer to Piston Pins and Connecting Rods Inspection:M13A .
icon : Apply engine oil to sliding surface of each part.
icon 6. Connecting rod bearing cap
: Point arrow mark on cap to crankshaft pulley side.
icon : Do not reuse.
7. Connecting rod bearing