1A
DTC P0560: System Voltage
NOTE:
• This DTC indicated only with SUZUKI scan tool.
• This DTC is detected, engine shuts off and won’t start.
Wiring Diagram
For wiring circuit and connector number, refer to “K9K Engine (Type 5)” in A-4 Engine Control System Circuit Diagram .
Detecting Condition
Status displayed on SUZUKI scan tool Detecting condition Indicator / Warning light operation
D1 Below minimum threshold Injection warning light (gravity 1 fault) light up
D2 Above maximum threshold
Troubleshooting
Measure the battery voltage when the ignition is switched on.
If the battery voltage is less than 11 V recharge the battery.
Check the connection and condition of the battery terminals.
Repair if necessary.
Check the vehicle’s charge circuit.
Repair if necessary.
Check the connection and condition of the ECM “E17” connector.
Repair if necessary.
Check the insulation, continuity and absence of interference resistance of the connections:
• ECM “E17-11” terminal for power supply circuit
• Between “E17-1” terminal of ECM connector and vehicle body ground
• Between “E17-2” terminal of ECM connector and vehicle body ground
• Between “E17-7” terminal of ECM connector and vehicle body ground
• Between “E17-8” terminal of ECM connector and vehicle body ground
Repair if necessary. If DTC P0560 is still detected, replace ECM.
After Repair
Deal with any faults detected by SUZUKI scan tool.
Clear the DTC.
Carry out a road test followed by another check with the SUZUKI scan tool.