1A
Fail-Safe Table
When any of the following DTCs is detected, ECM enters fail-safe mode as long as malfunction continues to exist but that mode is canceled when ECM detects normal condition after that.
DTC No. Detected item Fail-safe operation (symptom)
icon  
P0105 (No.11)
Manifold absolute pressure sensor circuit malfunction ECM uses value determined by throttle opening and engine speed.
icon  
P0110 (No.18)
Intake air temp. sensor circuit malfunction ECM controls actuators assuming that intake air temperature is 20 °C (68 °F).
icon  
P0115 (No.19)
Engine coolant temp. sensor circuit malfunction ECM controls actuators assuming that engine coolant temperature is 80 °C (176 °F).
icon  
P0120 (No.13)
Throttle position sensor circuit malfunction ECM controls actuators assuming that throttle opening is 20°. (High idle speed)
icon  
P0335 (No.23)
Crankshaft position sensor circuit malfunction ECM controls injection system sequential injection to synchronous injection.
(Cranking for a few seconds to start engine)
icon  
P0340 (No.15)
Camshaft position sensor circuit malfunction ECM controls injection system sequential injection to synchronous injection.
(Cranking for a few seconds to start engine)
icon  
P0500 (No.16)
Vehicle speed sensor malfunction ECM stops idle air control.
icon  
P1570 (No.21)
ABS signal circuit malfunction ECM controls actuators assuming that ABS signal is OFF.